JU-Gommaflex is a solvent-based nail polish cloths, paint for soft plastics, PVC sheets, tarpaulins circus to wrap, tarpaulin, tents, structures in pvc, truck tarpaulins, tents, camping tents, inflatable playgrounds inflatable rafts and boats in rubberized canvas layered flexible plastic and rubber. Good resistance outdoors, we recommend painting rubbers, pvc tarpaulins, tarpaulin, inflatable tires, decorative towels circus equestrian, lightweight rubber, inflatable playgrounds in to decorate.
CYCLE SOLVENT 'RECOMMENDED FOR OUTDOOR BLINDS AND CIRCUS EQUESTRIAN
Ready to use, dry to the touch 3 hours deep in 24-36 hours, full cure 7 days, accelerated in oven 30 minutes at 60-60 ° C. 50 Brightness Gloss. Application by roller or brush to get a good result. Spray application is more demanding and requires expert user. The product is suitable for decorate on inflatable playground for application with a brush or roller.
Yield: mq.8-10 per kg for hand
Designed specifically for 'brush application'
Outstanding grip and flexibility of PVC
Fast drying for fast production. Easily re-coverable
Widely used in the inflatable castle / inflatable industry
Make sure the surface to be treated is clean, remove all the fat, plasticizers surface are removed with an acid solution before applying the product. Store in sealed containers, to ensure that the loss of solvent is reduced to a minimum, otherwise the product loses efficiency and effect of flexibility of the film.
8-10 m² / lt
to the touch
N / A
N / A
Tips for painting: Be careful sheeting coils, before applying the paint unroll the rolls of PVC and it is important that the plasticizers (phthalates) products in the production process must exhale. To ensure proper adhesion of the paint these phthalates are to be removed and then lay the towel and wait for their exhalation. Ageing of towels, will migrate to the surface and can be easily removed, the PVC this is more difficult. Failure to remove them will cause adhesion problems. We always recommend that all new PVC sheets arieggino for a day with the atmosphere and as long as possible to ensure these plasticizers dispel - the material must be "odor-free" before applying the paint. E 'essential that all the substrate is thoroughly cleaned with degreaser and washed before painting. The paint must be protected from freezing and kept at a temperature of 7c +. The application process we suggest is the following:
1.-roll coating PVC "air" (at least overnight) before painting - this allows phthalates to escape.
2 Clean with PVC DEGREASER and make sure that the media is completely clean and dry.
3 Apply a coat of JU GOMMAFLEX brush or spray with expert sprinkler - only one hand is normally sufficient. On the bright colors (red / yellow, etc.), a second coat should be applied. Please allow at least two hours to wait between one hand and the next. The application of more than two hands is not recommended and may lead to delamination / flaking.
Keep in sealed containers to ensure the loss of solvent, is minimized - otherwise it loses the effect of flexibility of the film.
Note for users:
The information contained in this data sheet is based on the knowledge available to us at the date of the last version. Users must verify the suitability and thoroughness of provided information according to each specific use of the product.
It should not be construed as a guarantee on any specific product property. The use of this product is not subject to our direct control, users must, under their own responsibility, laws and regulations relating to health and safety. We assume no responsibility for improper use.